Dies ist eine alte Version des Dokuments!
show run | include snmp sh ru | inc snmp
Here is another useful command, but you have to think about what you are doing. I use this to see what snmp info is configured on a switch. However, it will only show lines that include snmp in them.
show run | begin ntp sh ru | beg ntp
Here is another handy shortcut I use a lot. The other day I was setting up ntp on a network. I wanted to see what ntp info was configured and since I knew ntp was at the end of the config, it made sense that I could start showing the config at the start of the ntp statements.
prompt>conf t enable#do sh run int gig 1/1
Dieser Beehl zeigt die Config des interface gigabit 1/1 ohne aus dem configurationsmodus raus zu gehen.